SONY FIRMWARE UPDATE MAC MAC OS X
SONY FIRMWARE UPDATE MAC UPGRADE
SONY FIRMWARE UPDATE MAC SOFTWARE
SONY FIRMWARE UPDATE MAC PASSWORD
SONY FIRMWARE UPDATE MAC DOWNLOAD

Make sure the camera is turnedВ ON and wait until the LCD screen appears again. Please waitвЂ¦вЂќ may be displayed for a few minutes before restarting.

Complete the update When the update is completed, the camera will automatically restart.

Note: Never turn off the camera nor disconnect the USB cable while updating. The progress bar appears while updating (approximately 15 minutes).

After resetting, reconnection of the camera is verified, and the screenВ below appears.

Note:В The screen turns OFF when the center of the control wheel is pressed.

Press the center of the control wheel to execute.

Turn off the camera, remove the battery pack, and then turn on the camera again. According to the message, stop the USB connection and click Finish.

SONY FIRMWARE UPDATE MAC UPGRADE

Note: If Current version is Ver.1.10, the upgrade is not required. After confirming current version is Ver.1.00, click Next.The LCD screen of camera is blinking.The current version and the version after the update appear on the lower left part of the screen. Note: From now on, do not turn off the camera until the firmware update is completed. If the computer has multiple USB terminals, try with the other terminals. Disconnect the USB cable and connect it again. Note: If the LCD screen of the camera dose not turn off, please try the following methods. Connect the camera to the computer with the supplied USB cable.Connect the camera to the computer Note: Remove the memory card from the camera beforehand.Note: If Date and Time setting is displayed when you turn ON the camera, you must complete all setting. Select Open when the warning message appears.The menu appears when you click the icon while pressing the Control key.The warning message вЂњFirmwareUpdater canвЂ™t be opened because the identity of the developer cannot be confirmed.вЂќmay appear when you double-click FirmwareUpdater. Note: If the pop-up вЂњFirmwareUpdater canвЂ™t be opened because the identity of the developer cannot be confirmed.вЂќ appears, refer to the following page.

SONY FIRMWARE UPDATE MAC PASSWORD

Type the password for the administrative account. To load a kernel extension, the message prompts you to allow the application to make changes.

Double-click the Firmware Updater icon.

Do not connect the camera yet at this point.

Double-click the downloaded file Update_DSCRX100v110.dmg.

Continue the operation according to the procedure вЂњStart up Firmware Updater.вЂќ.

Double-click the DL100_1411a Folder which appears on the Desktop.

Double-click the downloaded file DL100_1411a.dmg.

If you use OS X v.10.09 or lower, it is not necessary to run DriverLoader.

SONY FIRMWARE UPDATE MAC SOFTWARE

10.10 only) Note: If you use OS X v.10.10, running DriverLoader, a preparatory application, is necessary before software updates.

SONY FIRMWARE UPDATE MAC MAC OS X

Start Driver Loader (for MAC OS X ver.

Please save the downloaded file onto the Desktop of your computer (recommended).

SONY FIRMWARE UPDATE MAC DOWNLOAD

Download the update file Click on the file Update_DSCRX100v110.dmg to begin download.

We recommend that you use a fully charged battery. Note: The upgrade can be performed only when the remaining battery level is (three marks) or more.

Power source for the camera Fully charged rechargeable battery pack NP-BX1.

USB cable supplied with the camera Note: Update functionality is not guaranteed with any other USB cable.

RAM: 512MB or more * Please close all other application software and prevent your computer from going into Sleep Mode.

CPU Intel Processor (Core Solo and Core Duo processors are no longer supported).

System requirements for a computer Supported OS

If current version is 1.10, update is not required.

The System Software version is displayed.

Select Menu > Setup (3)В > Version on the camera.

Note: This update is intended forВ DSC-RX100 cameras that currenltly have a System Software version 1.00.

This update improves the vibration and sound noise of the lens when auto-focusing.

Sony is offering a software update for Interchangeable Lens Camera (DSC-RX100). Thank you for your continued interest in Sony products.

Sony firmware update mac